Can we get a GTR BOV install sticky?

[Godzilla.SK]

There's been a few threads on the topic but I still don't think it's been 100% covered. If someone has all the knowledge could you perhaps make a thread with all of the info for installing BOV(s) on a GTR? I mean, every bit of info from what types work best, what you need to install, any tuning required and the rest of it..

[nissanconvert]

agreed!

[GTR--J]

You need a 12mm wrench,srewdriver and a brain. :wink: If you don't have all the above ,take it to a mechanic.

[Godzilla.SK]

You need a 12mm wrench,srewdriver and a brain. :wink: If you don't have all the above ,take it to a mechanic.

******** asshole nobody likes the tuna here. :P

but seriously.. it's not that simple buddy. not everyone has the vast experience and knowledge of toretto's here.

[GTR--J]

There you go sport....I was just bugging ya :wink:

[Godzilla.SK]

There you go sport....I was just bugging ya :wink:

haha I know, hence the F&F quotage

[James Mramor]

on a GTR you need to remove the front bumper!

Then look on the drivers side and you will see 2 roundish things (stock BOV's) on the FMIC plumbing...

to remove and install:
2 screws on each side of each BOV... unbold old and bolt new BOV back on.(hoses just get replaced back on to the new BOV's "nipple")

replace bumper and tighten up the bolts for the bumper...make sure the "mud gaurd" is placed on proporly and off you go

this should take you about 40 mins if you have never done it before and have some mechanical apptitude, other wise take the extra 20 mins and go over everything X2

hope that helps!

[Godzilla.SK]

on a GTR you need to remove the front bumper!

Then look on the drivers side and you will see 2 roundish things (stock BOV's) on the FMIC plumbing...

to remove and install:
2 screws on each side of each BOV... unbold old and bolt new BOV back on.(hoses just get replaced back on to the new BOV's "nipple")

replace bumper and tighten up the bolts for the bumper...make sure the "mud gaurd" is placed on proporly and off you go

this should take you about 40 mins if you have never done it before and have some mechanical apptitude, other wise take the extra 20 mins and go over everything X2

hope that helps!

Perfectly clear. We should assemble on the info in recent threads into a sticky!