BNR32 build

[GTR_Nismo_bc]

I thought I would post my GTR build here and hopefully get some suggestions and help along the way. My GTR was a one owner car before I bought with 63,000km. Basically stock except for exhaust. It didn't take long after I got my hands on it to blow the turbos. After that I took the car off the road and decided to save up and buy a lot of the parts I needed to start a decent build.
MWRACING of VIP Imports has been a lot of help and he is helping with most of my modifications to the car. So if you need parts or service give him a pm.

Today I changed the front tension rods with Nismo rods.
[IMG][/IMG]
After removing the rods I decided to replace all the ball joints, they were way too sloppy, I bought Nissan OME ball joints. If your going to order tension rods, I would suggest getting new lower and inner ball joints too.
[IMG][/IMG]
[IMG][/IMG]
I took the front bumper off and intercooler.
[IMG][/IMG]
The old beat up intercooler and new HKS Spec R.
[IMG][/IMG]
I took the seats out.
[IMG][/IMG]
I have new OMP seats.
[IMG][/IMG]
I took off the downpipe.
[IMG][/IMG]
This is a piece of my turbo I found inside the downpipe.
[IMG][/IMG]
I'm replacing the downpipe with Greddy extension pipes.
[IMG][/IMG]
I took off most of the suction piping.

I have the HKS full piping kit.
[IMG][/IMG]
Parts
[IMG][/IMG]
I just got a Apexi Power FC and Commander from MWRACING. Thanks Martin.........
[IMG][/IMG]
I deceided now to sell the Greddy PRofec B boost control since now I have the Apexi FC, I ordered the Apexi Power FC boost kit.

Today I'm going to remove the turbos and manifolds. New turbos are Tomei Arms 7660 and Tomei Expreme manifolds.
[IMG][/IMG]
[IMG][/IMG]

[skylinemagic]

**** thats a good start

[APL]

Thats a ******* awesome part stack.

[CloudyGTR]

very nice, how much was the hks hard pipe kit?

[GTR_Nismo_bc]

very nice, how much was the hks hard pipe kit?

The HKS piping kit was around $1000.00

[bignate]

very nice man. HKS is top notch when it comes to piping. You won't find a better fit.

[R32GT-R]

i reccomend fitting the upper front pipes to the turbos on the bench. its a real bitch of a job any other way.

I got the same trust FP real nice bit of kit. thats 3 ppl i know of in canada who have it.

[mwracing]

thanks for the Shout Out about MWRACING.

I cant wait to see the numbers we put down with this beautiful setup you have gone with Mark. Top quality parts = reliability and substantial power gains.

[PH_Motorsports]

Are you upgrading the internals ? headgaskets ?

lookin good so far

[mwracing]

Are you upgrading the internals ? headgaskets ?

lookin good so far

I will let Mark answer this one