Running lights on r32 stopped working

**katecarlson** · 10-19-2011, 11:17 PM

About a week ago I was driving at night and my dash lights turned off and my running lights stopped working. The turn signals/high beam/ emergency brake lights on the dash still showed, but not the rpms or speedometer or anything did. I bought new fuses (10's) and found the appropriate spot by using a fuse tester and took out the fuse and replaced it, it worked for about 5 seconds, then it went out again and burnt the fuse. I looked under the hood and checked a relay that looked like it had been added, and then checked in the trunk to see if any lights were burnt out and they were all fine. And I don't want to seem like a dumb girl because I can't figure it out by myself, but I tried to figure it out before posting this. haha please help

**TheyKilledKenny** · 10-20-2011, 04:46 AM

Sounds like you have a short somewhere, electrical problems are a pain in the arse.

**craftz** · 10-20-2011, 06:33 AM

I think killed kenny is right about the short. Goto this link, third post down. Load wiring diagram and try to find affected circuit. Yea, wiring is a pain and time consuming.
http://www.boostcruising.com.au/foru...howtopic=29576