Compatible Parts List For GTS-T / TYPE M

**Hasley902** · 01-18-2012, 06:00 PM

anyone know if there is a compatiable front hub for a 91 gtst mine is cracked

**cschepp** · 01-18-2012, 06:03 PM

Ummmmm a r32 hub would work lol. Unfortunately man the hub is not compatible with any other vehicle

**Siscub** · 01-27-2012, 08:21 PM

Anyone know if there are compatible rear A-arms?

**beacher1B0** · 01-28-2012, 05:25 PM

C & P from your other thread.
Parts master says Z32 non turbo, A31, C33 and R32 GTS? is compatible. No S13 or R32 GTR.
However i believe s13 is the same but thats not what Nissan Parts Master says.

Originally Posted by Siscub

Anyone know if there are compatible rear A-arms?

Nissan Part Master people, Nissan Part Master. This whole section could be deleted if everyone had it. Find the Nissan Fast program 2006, Parts master is included in it. GTRPdoubleUR.com. Sorry Mcfly.

**feyd182** · 03-01-2012, 09:19 PM

Finally found a listing for hicas rear outer tie rod ends(ball joint pressed into knuckle). But the kicker is my cost is $172 each. Soooo I think my supplier has got the wrong listing. I will dig deeper and post up here. If I can source them I'd be willing to order some for guys on here who need em.

Sent from my iPhone using Tapatalk

**Supraclean** · 03-02-2012, 02:12 AM

Originally Posted by feyd182

Finally found a listing for hicas rear outer tie rod ends(ball joint pressed into knuckle). But the kicker is my cost is $172 each. Soooo I think my supplier has got the wrong listing. I will dig deeper and post up here. If I can source them I'd be willing to order some for guys on here who need em.

Sent from my iPhone using Tapatalk

I'm pretty sure I paided a pretty penny from Ztune(now monkeynutz) for these aswell so your price might not be that far out.

If I had to do it again, I'd just my a driftworks or Ams lockout kit for the price you would pay for a lockbar/tomei system + Inner/outer tierods.

But anyone is at the same point as you could be a good group buy:P

Sent from my BlackBerry 9700 using Tapatalk

**feyd182** · 03-13-2012, 07:42 PM

Just confirming that a 1990 N/A 300ZX clutch, pressure plate, pilot and release bearings fit a GTST perfectly. Just installed one today for a client of mine. Also confirming an RB26 flywheel will work as well.

Sent from my iPhone using Tapatalk