MAF upgrade for HCRs?

[beacher1B0]

I am going to need a upgraded MAF for my current build. Will a N62 300zx Maf fit my HCR Blitz SUS Power Air Cleaner and factory turbo intake?
Also what about the Nismo MAF?
I plan on running Nistune, is there any options there?(MAP vs MAF)
Ive done some searching and havent had a concrete answer to this problem.
Thanks in advance,
Mike

[BrianV8]

I know the z32 300zx MAF is a direct replacement just have to wire in a new pigtail and have a ecu tuned for it. I dont know about that N62 though. As far as nistune goes i was told that you are able to change from MAF to MAP or tune for different types of MAF's. Don't quote me on that but someone on here should be able to confirm.

[Skym]

I see.

Z32 MAF (300ZX/VG30DETT engine) or Q45 MAF (Infiniti/4.5litre Nissan Veight engine).

Nistune only works with MAF. Tomei Reytec which is similar uses MAP sensor on GTR only which has AIT (Air Intake Temp) sensor. RB20DET ECU doesn't have a stock AIT sensor, so can't run a MAP sensor setup.

[beacher1B0]

Thanks BrianV8,
So the 300zx MAF will bolt up to my HCR Pod filter?.
I searched the Blitz SUS Power Air Cleaner P# and they are different for RB20 and RB25. Just want to make sure, thats all.

Thanks,
Mike

[BrianV8]

No problem, 300zx MAF is physically identical, i have one sitting at my place currently just waiting for a chip to get tuned so i can install it. Like i said though the connectors are different so if u buy one make sure u get the pigtail so you can wire it up.

[beacher1B0]

Nice Nice. Another question answered. Thank You.