Steering Boots

[gtst_skyline]

Any idea how hard it is to change the power steering boots on a r32? And dont tell me to search. Im looking for someone who has done it and can tell me how hard it is. Thx

[S13Jordie]

if its the same as on a 240, which i think it is, just take the tie rod off and slide it out. replace and there ya go.

[gtst_skyline]

Ok cool thx

[Black BNR32]

you'll probably need something like this to get the tie rod out:

http://www.princessauto.com/workshop/hand-tools/automotive-tools/auto-repair/8105223-pitman-puller-arm

also, I had a tough time getting the damn boot on to the rack. it just takes some messing around.

budget for a couple hours imo

[M13]

you'll need an alignment after because you'll be removing the outer tie rod.

You don't need that puller either, just a few strikes with a good 10oz will do.

[caliber676]

If you want to get away without doing an alignment just tape the rod so the edge sits against the nut, then mark the nut and tie-rod end then match em back up when your putting it back together. Technically you SHOULD get an alignment, but if your marks are good you won't really notice a difference, and if your on a budget.