R33 4 door GTR rear wing

[RSi]

Bought this by accident... looking to sell..

YES - its from an R33 4 DOOR GTR.

Accepting offers.

Pics to follow.

[Dragon Humper]

Hah!!! I knew you couldn't take a Saws-all to it, good for you, super rare piece.



Jon.

[RSi]

hahaha
I'm itching to cut it up! So far no offers!

[frankiman]

no far no pictures

[RSi]

[DougTaylor]

Do you know if the 4-door wing fit on the R32 GTR? Or are you selling because it doesn't?

[RSi]

Dunno I bought it for my 33 GTSt and it looks like this....



I can extend it no worries, but people are telling me its too rare to do that.

It looks sick from the side...

[RSi]

If anyone local wants to size this up on their R32, they are welcome...

[DougTaylor]

Can I ask you to please send me a couple of measurements? My trunk lid doesn't have the same holes as yours at the front. A measurement from outside edge to outside edge of the base and from the inside of the curve that fits on the back of the trunk lid to the front of the piece that you're not going to extend. I should be able to figure out if it will fit based on that I think. I've also seen one of those wings on an R32, I'm just not sure if you need to replace the whole trunk lid. Lastly, what are you thinking for a price? PM me if you don't want to post it.

Thanks
Doug

[RSi]

Yep I'll measure tomorrow. No clue what I am after as I dont know what its worth... I'd just rather not cut it up....

[hozer]

Measurements of the GT-R trunk. Measured from where the lines run. Green line is the space between original holes




Fender to fender width of 32 and 33 are only 3cm difference so the wing should be a pretty damn close fit

[got_boost!]

That does look pretty damn good on your car. No way to make it look good without chopping it?

[DougTaylor]

Yep I'll measure tomorrow. No clue what I am after as I dont know what its worth... I'd just rather not cut it up....

There's something I'm not getting here - why would you cut it up instead of filling those holes and tracks at the front of your deck lid? I do think the wing looks cool - always have, but I can't understand why you don't keep it.. If it fits on the r32 I'll make you an offer, I have family in several areas of GVA, so it shouldn't be an issue for you (i.e. no shipping)..

[DougTaylor]

Dude, assuming this is for the r32, you rock! Thanks! That sure saves me some time..

Measurements of the GT-R trunk. Measured from where the lines run. Green line is the space between original holes

Fender to fender width of 32 and 33 are only 3cm difference so the wing should be a pretty damn close fit

[RSi]

There's something I'm not getting here - why would you cut it up instead of filling those holes and tracks at the front of your deck lid? I do think the wing looks cool - always have, but I can't understand why you don't keep it.. If it fits on the r32 I'll make you an offer, I have family in several areas of GVA, so it shouldn't be an issue for you (i.e. no shipping)..

The R33 has a groove up the sides of the trunk where the spoiler sits into, AND it sits lower than the rear 1/4s. Filling the holes would still look stupid.