Announcement

Collapse
No announcement yet.

Dyno Results with water meth

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • evilgtr
    replied
    ^ I love modded pulsar they rip for a little car, but investing money in a super duty would be a big second mistake. The first mistake would be buy a ford diesel haha keep us posted on the pulsar mods

    Leave a comment:


  • NismoS-tune
    replied
    Originally posted by gtrjon View Post
    with your set up something really doesnt seem right with that at all...
    Meh, my $6k Pulsar with 1.1bar is quicker that an R33 GTR with exhaust/intake/1bar haha. Makes me wanna sell the GTR, put 5k into the pulsar and the rest in a super duty truck!!

    Leave a comment:


  • menace
    replied
    I finally found some at my local CT. The shelf space where it sits is always empty, but there was a whopping 3 on the shelf this time. Was selling for $9.99, so I snagged one to hold me over for now. I've been back a few times and I never see more then a handful on the shelf.

    Leave a comment:


  • Dragon Humper
    replied
    Originally posted by menace View Post
    Sweet thanks for the tip!

    I assume that is the windshield washer fluid without detergents in it when you say "stocked up for winter"?
    Nope, straight 99.7% pure methanol (called MethalHydrate though because it has some water in it). It is supposed to be used to de-ice your fuel in small quantities and to de-ice air brake systems. I burn about half a gallon per tankfull with a gallon of Tolulene to give me a mix that will tolerate 24psi of boost and 32 deg. of ignition timing.

    If I am feeling saucy I'll dump in 2 gallons and bump up my temp correction to give my whole fuel map a 20% increase across the board. This and the Tolulene gives me a huge safety factor when the outside temps are above 30 deg.

    I am toying with the idea to put in 1600cc injectors and run a 40% Methanol mix for next year.



    Jon.

    Leave a comment:


  • curtisgoodman
    replied
    Originally posted by gtrjon View Post
    with your set up something really doesnt seem right with that at all...
    what he said... i made 376awhp at 1 bar with -5's at RG's heartbreaker mustang dyno... and that was my break in tune... then made 510awhp at 28psi with water meth at RG afterwards...

    Leave a comment:


  • gtrjon
    replied
    Originally posted by NismoS-tune View Post
    Nah,that's not bad. I made 300whp at 1 bar on -5s and I have, in my opinion, had pretty beefed up car.
    with your set up something really doesnt seem right with that at all...

    Leave a comment:


  • NismoS-tune
    replied
    Originally posted by cobrAA View Post
    sadly, I only made 336whp , my tuner def. choked this one, I will need to talk to him tomorrow. its almost impossible to make that low of a number lol.
    Nah,that's not bad. I made 300whp at 1 bar on -5s and I have, in my opinion, had pretty beefed up car.

    Leave a comment:


  • hozer
    replied
    Originally posted by newalliance123 View Post
    Any trouble tuning with it? I'm tempted to go that route with a single TB just to clean up that half of the engine.
    Wouldn't say 'trouble' but the tune is a little more finesse. Takes a little more work to get right IMO

    Leave a comment:


  • newalliance123
    replied
    Any trouble tuning with it? I'm tempted to go that route with a single TB just to clean up that half of the engine.

    Leave a comment:


  • hozer
    replied
    Originally posted by newalliance123 View Post
    Hey hozer what intake manifold is that?
    KU Engineering

    Leave a comment:


  • newalliance123
    replied
    Hey hozer what intake manifold is that?

    Leave a comment:


  • menace
    replied
    Sweet thanks for the tip!

    I assume that is the windshield washer fluid without detergents in it when you say "stocked up for winter"?

    Leave a comment:


  • Dragon Humper
    replied
    Crappy Tire, $7 a gallon in the fall when they are stocked up for winter, I by about 10 of them and am all set up for next summer. I don't inject it, I just burn it in my fuel.



    Jon.

    Leave a comment:


  • menace
    replied
    Thanks very much for the reply!

    I live in Oakville, ON and I know you can get it from places like Home Depot even, but its something like $12 a gallon. I read that people are getting it from "speed shops" for as cheap as $2.50 per gallon.

    I have Johnston Research & Performance pretty close to me but they are not known to be the cheapest shop. I'll check there since the hardware store jugs must be laced with gold flakes.
    Last edited by menace; 09-29-2011, 10:10 PM.

    Leave a comment:


  • collector240sx
    replied
    Originally posted by menace View Post
    Where is the best place to pick up methyl hydrate? Also, when you guys mix it 50/50 with water, is that distilled water or just plain old tap water?

    Thanks!
    I just buy it by the box (4 jug of 3.78L I think) at Marshland, they seam to have the best price around here. Not sure about where you live tho.

    PS. I noticed that no one talked about using windshield washer fluid, there's a few people around my place using it. (It's basically meth already diluted, not sure what the percentage of meth is in them tho) It's cheap and easily accessible. I prefer going with the real stuff and making my own mix, but for people simply using meth has a security measure (not tuned for the meth), it's a good cheap alternative.
    Last edited by collector240sx; 09-29-2011, 09:53 PM.

    Leave a comment:

Working...
X