GTR Wheel Fitment Thread

[curtisgoodman]

http://www.workwheelsusa.com/news-post.php?article=98

-R32 Gtr

18x10 +18

Thoughts? Fitment?

[Nismo_line]

does 18x9,5+12 with 265/35r18 fit on r32 gtr without any bodywork?

yes they will fit. you wont need to do any fender rolling.

[mistercrow]

does 18x9,5+12 with 265/35r18 fit on r32 gtr without any bodywork?

[Dragon Humper]

K, I have a fitment question: I'm looking at picking up some wheels, but I'm not sure about clearance on the inside.

18x10.5, +38mm running at 265.

Just curious if anyone can chime in I might have issues ( for a BNR32)



Sent from my iPhone using Tapatalk

That wont be an issue with an 18" wheel...17s have issues with a high offset (I had to grind the little bump off the end of the tierod to run a 17x10" +42 on the rear....no spacers). The rear should look fine but the front requires a bit less offset to not look goofy. On the flipside though, you can run a much wider tire with more offset, I run a 9" +18 on the front and a 245 is as wide as I can go. With a +30 on the front, I could go as wide as 275 on, say, a 9.5" wheel on the front with no rubbing issues and still look OK.



Jon.

[dak24]

would i have to get my fenders rolled?

[Harvey]

You will be fine.

[dak24]

Hey guys, I have a quick question. I've been looking at rims for my R33 GTR and the wheels I'm looking at are 18x10.5 with a +22 offset. Should I have any fitment issues with that kind of wheel?


Sent from my iPhone using Tapatalk

[RixR32]

K, I have a fitment question: I'm looking at picking up some wheels, but I'm not sure about clearance on the inside.

18x10.5, +38mm running at 265.

Just curious if anyone can chime in I might have issues ( for a BNR32)



Sent from my iPhone using Tapatalk

That offset is too high. Besides looking odd, you will most likely have fitment issues. Also depends on backspacing, which is a different meaurement than offset. Im running 17x10, +20 and I can just stick the tip of my baby finger between the inner lip and balljoint. Worst case grab some 15-20mm spacers if you really like the wheels.....


Sent from my SGH-T769 using Tapatalk

[skylineftw]

K, I have a fitment question: I'm looking at picking up some wheels, but I'm not sure about clearance on the inside.

18x10.5, +38mm running at 265.

Just curious if anyone can chime in I might have issues ( for a BNR32)



Sent from my iPhone using Tapatalk

[Nismo_line]

yes i did. even tried comparing to oem wheel size

[bobbo]

Did you use this?

http://www.1010tires.com/Tools/Wheel-Offset-Calculator

[Nismo_line]

after calculating it, that size will only stick out 1mm more then a 18x10.5 +12 that i wanted to run. just wanted to make sure the back spacing wouldnt have problem with clearing any brakes or suspension. offset calculator also says i would have 13mm more inner clearance then the 18x10.5 +12

[bobbo]

They'll certainly clear the brakes. Rubbing on fenders could be an issue.

[Nismo_line]

I am looking at a set of bbs lms. Specs are 18x10 +5. Would i have a problem with clearing the brakes at all?

[Skynet1]

Any other R33 Gtr fitments??