How to get awd codes from trunk?

[cschepp]

I know for the ecu up front it's pretty easy and straight forward but I am still have a problem with my awd system and don't have it working yet. If someone could tell me how to get the codes to flash that would be great.

Checked for this all over gtrc and no dice!

[NeptuneGTR]

just count the flashing lights, there can be more than one code so just make sure you got them all




1 Right front wheel speed sensor or circuit
2 Left front wheel speed sensor or circuit
3 Right rear wheel speed sensor or circuit
4 Left front wheel speed sensor or circuit

5 ABS right front wheel actuator solenoid or circuit
6 ABS left front wheel actuator solenoid or circuit
7 ABS rear wheel actuator solenoid or circuit
8 ABS actuator motor, motor relay or circuit
9 ABS actuator relay or circuit

10 ETS control unit power supply or circuit

11 Fore-and-aft G sensor 1 or circuit
12 Fore-and-aft G sensor 1 or circuit
13 Fore-and-aft G sensor 1, fore-and-aft G senstor 2
14 G sensor power supply 1 or circuit
15 G sensor power supply 2 or circuit
16 Lateral G sensor or circuit

17 Air bleed connector or circuit

18 ETS pressure switch or circuit
19 ETS motor, motor relay or circuit

20 ETS solenoid or circuit
21 Throttle sensor or circuit
22 ETS oil level switch or circuit

23 -

24 or ON ETS control unit, ground or circuit

[DarkCaporaL]

There should be a delay of 1 second between flashes for the same code, and a delay of 3-4 seconds when it switches to another one.

Ignition switch might need to be ON in order for the ATTESSA ECU to throw the codes, not certain on this though.

[cschepp]

So all I need for the light to start flashing is have it in the on position? If that's the case I feel retarded right now

[DarkCaporaL]

Either in the ON position or the car started, the manual isn't too clear on this...but usually for most things it's the ON position.