HKS super bov install.

[Voodoo_ChildR32]

Has anyone here run one of these bad boys? I've been playing around trying to get them to work and hold boost. I'm wondering if I have all the vac lines routed properly. If anyone can tell me where to connect both the rear and top nipples to.

This is the BOVs installed in my car.


Sent from my iPhone using Tapatalk 2

[h4X6]

no sure about the side ones, but i think you hook up the top to boost/vacuum source aka after throttle body

[strickaj]

There was a set on mine when I bought it. All 4 nipples were conected to 1 hose coming off the plenum. I'm almost 100% that was not correct but it did function. 1 set should be pre throttle the other post, just not sure which. I have a broken 1 laying around maybe I can take it a part and get a better idea of how it works. Hope that helps a little.

[Voodoo_ChildR32]

^^^ Yes, this makes sense, just don't know which nipple is which, lol.


Sent from my iPhone using Tapatalk 2

[Bossman]

http://www.supraforums.com/forum/sho...ith-2-nipples)
These look like the older push/pull type BOV. The top ones should connect to a vacuum source form the intake after the throttle and the side nipples should connect to a positive pressure source before the throttle. Make sense?