r32 gtr connector info

[mistercrow]

Hey guys, i was about to start a r32 gtr today and the fuel pump had no power, so i check out the wiring today the fuse has 12v but no power in the back at all.

i found a connector that has not been plugged in, and i dont see to find where i goes too. part may be missing on car.

the connector im talking about is in the rear right pannel, under the quarter glass, it has 7 wires, colors are
lt lt green spotted, black/yellow, black double spotted, black spotted, white spotted, and finally darkgreen /white.

its close to the wires that go to atessa 4wd.

is that connector fuel system related? can anyone post me a picture of where it goes to, or if there is a module that i am missing? thanks alot guys.

[steveo1502]

It's the fuel pump relay... Or something for the pump, you'll need that

[steveo1502]

I think I have an extra, did you ever find the driveshaft center bearing you were looking for? I might have one of those also

[R32-90]

What year is your R32?

Under the driver's quarter glass there should be a metal bracket held by 3 or 4 M6 bolts, bolted to the unibody. Behind that bracket sits the fuel pump module It has an 8 pin connector. If thats missing, thats a problem.

[steveo1502]

[R32-90]

Ay, thats the one.

The relays are in the rear of the boot, under the latch.

[rvander1992]

I have one of those computers sitting around if you need it.

[mistercrow]

hey guys. yes it is missing. does that only have to do with fuel? or it also causes igntion issues? here is the real issue im trying to solve.

btw, yes i found the bracket. thanks though.

heres the deal:

r32 gtr shell, nothing inside at all getting full rebuilt. I had "all" parts with it when i baught it. exept you know, a **** loads of stuff, as usual when buying a shell

So heres the deal and why im asking for the module.. engine cranks. i have rewired my fuel pump to direct battery voltage + chassis ground with a relay and got the fuel pump to work.

Now today cranking the car, gaz go to the injectors, everything is fine gazwise.

still no start.

move onto part 2:
part2: figure out no spark at all, the ignition module isnt even getting signal.

does the module under rear driver side glass give out ignition info or nothing at all?

i have searched on the internet and a couple of people write down to check ignition connecter (3 pin, white, red/black, and black) for 12v. i get 12v only on the white wire, and nothing else. should there be power to red/black wire?

anyways, if you guys have had similar issues and can help me out id be grateful. thanks

[rvander1992]

I have another computer for back there as well, was either 4wd or hicas, same looking as the fuel relay. Not sure if you need that.

I don't think you need power on red and black. Blacks are grounds, red might be power but i believe its signal(which plug sparks in what order) and white would be power.