Replace Vaccum lines

[Supraclean]

Wanted to replace all my vacuum lines, hoses from valve covers for oil catch can. Also looking to swap them out becuase I am switching my intake manifold from stock to a tumpet style. Bascily Im wondering it what kinda of hose shouldI been buying for heat ect, I should just pull off a few lines and just measure the ID. Juat wondering if you guy had and ideas, suggestions, tricks of the trade to share.

Was looking at these

http://cgi.ebay.ca/ws/eBayISAPI.dll?ViewItem&item=350237241974&ssPageName=STRK:MEWAX:IT

[DreadedFist]

If it's just vacuum hose you need, assuming its not near anything hot, you can pick it up at pretty much any autoparts store, maybe even home improvement stores too. If the new intake manifold places any of the vacuum lines to close to hot components, you could always get some heat wrap for them, or get some Earls flame guard hose, that fits over the hose/wiring that you want to protect.

Why order something from China that'll take forever to arrive when you can keep your money in Canada, and get the stuff you need in like, what, maybe 20 minutes depending on where you live?

[whiteboy87]

yah autovalue or partsource for line gets the job done just as well

[Supraclean]

Yea I sopose, I wanna hunt down hose that it a pretty color:P Is that 2 much to ask?

[markc32]

for 5/16 vac lines i think its ok to use transmission/fuel hoses and it can stand heat in the engine

as for the catch lines...home depot water hose! clear

[Supraclean]

Hey thanx alot guys for your input. Yea Mark I totally went with the clear catch lines, I think it will turn out nice.