My new and first skyline, lil help please:)

[dimpoblimpo]

alright i finaly got my skyline gts-t with a nice rb25 swap an i had a couple questions.

1. When i start my car it idles a little above 1rpm then slowly decreses until it just shuts of unless i slowly rev it until the temp gauge kicks in. what causes this? It takes longer when the longer it sits.

2. the window lining on pretty much every window is shotty, how would i go about replacing it and any ballpark cost ideas?

3. car sits a little low and i get some wheel rubbing on the rear fenders on sharper turns any cheap solutions to pop her up a little?

thanks, in advance. take a look

had a lil leak from the gas return line, well clamp fell off, but its all good now. it explains the crap load of gas on the road..

[quadracer111]

Very nice car.

If your car is lowered it probably has coilovers, find out what kind they are, then find the instructions and just raise them up.
No clue about #1 and I would also like to find out about #2.

[dimpoblimpo]

thanks
im not sure if its lowerred but it probably is, it hits the fenders though maybe because there widened gtr fenders? if i take off the wheel spacers its alright. and i cant roll the fenders beacuse there not steel.

[quadracer111]

Ohh, I never seen the gtr wide fenders...

Sorry, I dont know... But I would find out if you have coilovers or aftermarket struts and or springs.

[flipridah17]

If you are after a full kit for windows contact Adam (FEAST) or Daryl (Tunerlab).

I believe the pricing on both windows are 400 -450CAD shipped.

They cost an arm and a leg but well worth it..

As for you rears rubbing, if you have coil-overs you can definitely adjust it for better stance.

Good Luck

[M0nkeyMark]

http://www.youtube.com/watch?v=f_ZWIcl4_HI i knew i recognized this 32

[dimpoblimpo]

thats her lol. Cjay is the man responsible for the amazing work done to this car

[all-Canadian11]

possible solution for #1, check your injectors make sure there are no leaks, and also check your MAF it could be dirty.
I had a similar problem with mine, cleaned the MAF and seems to be running fine now.

[rb26addict]

i swear i seen u driving this ******* guy u worked at futureshop newmarket ..... a lie ??

[dimpoblimpo]

its still without plates, so i doubt it was me, creepy tho i did work at that same futureshop tho haha.

[DreadedFist]

who makes those rear fenders?

[rb26addict]

i could have swore i seen u driving it around aurora richmondhill ways .....n its just i work a that futureshop so i was like yoooo thats that guy that got booked by dave hahah jks

[Oakville]

why the 401 dixie plate frames?

[kyles_r32]

when it idles high is it only when the engine is cold or when its hot or both??

[dimpoblimpo]

lmfao how do you know this. lol i did work there. dave framed me, he told me that i stole an ipod touch cover. Lol whats your name did we work together