hcr32 front inner and outer tie rods

[esh]

I've been reading all kinds of information (some contradicting) about which front inner and outer tie rods fit hcr32 both on this forum and all over the internetz

I just want some definite answers!

From nissan fast:

Front Inner Tie Rod: 48521-72E06

Front Outer Tie Rod: 48520-71L25


So can I use 90-96 300zx front inners and outers? 95 Maxima outers?

How about aftermarket?

Would these fit?: http://www.amsmotorsports.com/shop/i...e-rod-kit.html

[92GTSTproject]

beef it up and forget about them

http://www.driftworks.com/shop/tein-tie-rods.html

[esh]

beef it up and forget about them

http://www.driftworks.com/shop/tein-tie-rods.html

I'm not completely sold on the whole "beef up your tie rods" idea. If something were to break, I'd prefer it being the tie rods than the steering rack.

[92GTSTproject]

most of the time you never acctualy break a rod usualy just bend them even then the beefier ones are still weaker than the rack there just less prone to bending

its really hard to mess up your rack if any thing pushes on it it just slides through