R32 Dashboard Warning Lights

[supreme]

I would like to know if anyone could take a picture of their dash with all of the warning lights lit up. I have a few that don't light up when the key is turned. Any help is greatly appreciated.

Thanks

[supreme]

here is what I have lit up from right to left:
BLANK HICAS BLANK SEATBELT
E-BRAKE BATTERY ExhTEMP DOORS


Sorry for the dark image

[supreme]

I think i have it figured out, the first blank is most likely check engine and the second blank is probably washer fluid, the only thing now is to find the appropriate bulbs to replace the dead ones, I will most likely do that tomorrow and report back to help those with the same problem.

[specialedition]

mine looks the same as that.

[supreme]

I took apart the cluster because I had the dash off anyway (adding running lights and clutch safety switch for inspection) and discovered that the two that I am missing are ABS and 4WD, two features which I do not have which explains why there were no bulbs behind them. I will post pics if my phone co-operates. Also discovered a cruise light under the blinkers, and no sign of an SRS airbag light which I will use as proof to pass inspection as well.

EDIT: Here are the photos

[Skym]

Exhaust overheat light on dash acts as a engine check light as well (flashing ECU error codes). I had that happen when stock ECU diagnostic pot / screw was not fully in run mode and that light would light up when hit a bump in road.

Handbrake can light up if fluid is low in brake fluid resouvoir (leaking brake hose, leaking brake caliper, leaking brake master cylinder are the usual causes).

HICAS light can light up if fluid is low in powersteering resouvoir.

[supreme]

Thanks, this is great info to know. I was wondering about the engine light (or lack there of). Originally I was worried because I thought that a light might have been removed because it would look better on the part of the seller. I am glad this is not the case because who knows what could have been wrong. Also I really liked doing buisness with the guy, he seemed honest and it turns out he was. Thanks everyone problem solved.

[Skym]

You're welcome. If beeper wasn't removed from behind the dash (some remove beeper due to beeping when hit speed cut, leaving light's on, etc), the dash can beep when voltage is below I think was 12 volts on battery. But that dash has a battery warning light, so it might light up at same time. Also that beeping happens when trying to turn engine on.

[amnash]

i want to install cruise...

[rob_96]

its ok, my hicus lights does not come on, i have front axles but no awd light come on when key is turned on, i have a huge misfire after driving for 30-40 min and when i go to pull the codes there is nothing has five long flashes and 5 short flashes.