Tweet
these were made 100% in-house, completely designed and built from scratch by PUR's head fabricator Adam
using a combo of mild steel flat bar, square stock and angle iron
they are insanely strong
this particular set was made for a side-mountable seat and the result is that the seat is literally dumped on the floor, as low as it can physically be
if you're wondering how much, these ones took about 6 hours to make (for 2 seats), plus materials, so figure a cost of about 500 bucks. i know that's pricey but it's mostly because there's no jig to base them on. the driver side is 100% custom tailored to the driver.
the passenger seat was done going the stock rail route. it's been adapted to the stock 240 rails so it retains the fore & aft sliding function. the trade-off is that it sits higher.
we also supply Sparco seats at competitive prices.
pics below are of the raw product, straight from fab.
they will ultimately be cleaned up and professionally powder coated
using a combo of mild steel flat bar, square stock and angle iron
they are insanely strong
this particular set was made for a side-mountable seat and the result is that the seat is literally dumped on the floor, as low as it can physically be
if you're wondering how much, these ones took about 6 hours to make (for 2 seats), plus materials, so figure a cost of about 500 bucks. i know that's pricey but it's mostly because there's no jig to base them on. the driver side is 100% custom tailored to the driver.
the passenger seat was done going the stock rail route. it's been adapted to the stock 240 rails so it retains the fore & aft sliding function. the trade-off is that it sits higher.
we also supply Sparco seats at competitive prices.
pics below are of the raw product, straight from fab.
they will ultimately be cleaned up and professionally powder coated
Comment