Still new to the forum, so i hope this is in the right section. Anyways, been tinkering on my 'Line all winter and about to roll her out for the first time this season but i have a bit of an issue. I installed a TIAL BoV and the hood doesn't clear it. I put the OEM hood on to test it out and not only did i put a dent in the hood but i screwed up the hood release handle cause it had too much force pushing up on it. (Augh)
My question is is it against any laws that anyone knows of in Alberta to drive with the engine bay exposed. I ordered a CF hood with vents that should hopefully clear it but still i don't want to waste all this beautiful weather driving my shitbox winter beater for another couple weeks or so till it arrives.
Also any recommendations on how to get around this clearance issue would be appreciated too
*just a side-note too, i DID do a search on the forum for anything involving this and couldn't find anything. And i'm still looking through stupid amounts of PDF's on Alberta traffic laws.
My question is is it against any laws that anyone knows of in Alberta to drive with the engine bay exposed. I ordered a CF hood with vents that should hopefully clear it but still i don't want to waste all this beautiful weather driving my shitbox winter beater for another couple weeks or so till it arrives.
Also any recommendations on how to get around this clearance issue would be appreciated too
*just a side-note too, i DID do a search on the forum for anything involving this and couldn't find anything. And i'm still looking through stupid amounts of PDF's on Alberta traffic laws.
Comment