If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Lets see everybody's current maps. Here's my work in progress on an rb26, djetro, 280/10.8 cams, -5 turbos, 750cc injectors set up. I'm getting some lean numbers at tip in from idle, and gonna work on it tomorrow.
When i get my vipec installed there will be an abundance of this kind of info on my build thread I'll do a basic tune myself but then take it to a tuner to fine tune on a dyno , last time i tried to log data driving it on the road the experience didn't end too well lol.
I don't think there are too many people on here that tune their own maps , an RB engine is not a cheap engine to ruin if you're learning this process lol.
Hard to tell if your A/F ratio or ignition timing is correct without looking at dyno run to confirm (changes in torque, hp on graphs, A/F ratio changes, boost plot changes, etc).
That fuel map looks like a stock fuel map, uncorrected for injectors, cams.
This is a great idea! I have a Power FC with a datalogit on the way and plan on doing a basic tune myself before taking it to a proper tuner. Looking forward to learning the basics of tuning and will have a few questions for those with experience.
Comment