I don't want people to think I'm nerding out hard here but I'm going to do my best to replicate my in car dimensions. Once I have the G25/G27 I'll be buying the adapter to run my sparco deep dish wheel, and make up for the discrepancy between my hub length and the adapter length.
- Measure the height from the ground to the center of my wheel in my skyline
- Measure where I usually put my seat. (I'll probably take my seat out for the winter anyways)
- Measure the distance the shifter is (in neutral) fron the center of my steering wheel)
- Measure the distance the pedals are from the seat, and from the wheel
And just make a little frame out of some 1x1 wood. (Have lots left over when parents were boxing in the pillars in our basement)
Overall it might take me a few hours to do, but the final product will be the closest replication of driving my car I can make without spending stupid money this winter. I just need to figure out how to put my shift knob on
- Measure the height from the ground to the center of my wheel in my skyline
- Measure where I usually put my seat. (I'll probably take my seat out for the winter anyways)
- Measure the distance the shifter is (in neutral) fron the center of my steering wheel)
- Measure the distance the pedals are from the seat, and from the wheel
And just make a little frame out of some 1x1 wood. (Have lots left over when parents were boxing in the pillars in our basement)
Overall it might take me a few hours to do, but the final product will be the closest replication of driving my car I can make without spending stupid money this winter. I just need to figure out how to put my shift knob on
Comment