Dead clutch pedal

[bellis_GTR]

Another problem with the car


I was driving, dropping my friend off and once I pulled into her driveway my clutch pedal went right to the ground as I put the car in neutral. It went stiff again for a sec when I put it in reverse but when I wanted to put the car in 1st the clutch went to the ground and didnt come back up and could not get into first. I finally got the car home by putting the car in 2nd and starting trying to make it turn over and just drive straight home. I got home and looked under the car and there was grey sparely fluid on the ground. I put some dot 4 brake fluid in the car and had a friend pump the clutch and it completely drained right out under the bell housing. Is this the slave cylinder or something else? And if its the slave is it located under the driver side on the right of the tranny? Is it push or pull type? Sorry Im still learning part names.

Any help would be great! Pics if you can!

[MarusGTR]

The only thing I can help you with, it's that it's probably a push type (pulls are on R33 v2 and up).

[GTS-James]

what do i use for clutch fluid??? do i use dot 4 brake fluid? just finishing up my clutch change

[bellis_GTR]

what do i use for clutch fluid??? do i use dot 4 brake fluid? just finishing up my clutch change

you can use dot 3 or 4.

[bellis_GTR]

The only thing I can help you with, it's that it's probably a push type (pulls are on R33 v2 and up).

Thanks man! I was kinda thinking the same.

Any other help would be great guys!

[Shane_Sawatzki]

yes the slave is on the driver side of the tranny, push type. this sounds like your problem if thats where the fluid is coming from.

[frankiman]

clutch slave cylinder is on driver side,
it maybe your rubber clutch line that is broken
you can use dot3 or dot4 brake fluid for the clutch
pull type clutch are one 1994+ GTR , the 1994 v-spec BNR32 had a pull type

to bleed clutch;
http://www.skylinesaustralia.com/for...h-t176479.html

[bellis_GTR]

@ Shane_Sawatzki - Thanks for clearing that up!

@ frankiman - The rubber clutch line your talking about, is that the one coming from the slave up to the mater cylinder? And thanks for the DIY!

Does anyone have a good condition clutch slave cylinder? PLEASE LET ME KNOW! Need it before CSCS!

[frankiman]

the rubber line comes off the slave and is about 6" long, it connects to the harlines

[derbeck]

Hey if it's the slave I have 1 in k-w

[bellis_GTR]

Hey if it's the slave I have 1 in k-w

pm'ed