Tweet
I did degree the cams but I will double check. Again, why only 3&4 and not all the cylinders if my cam was out align?
I'll keep you posted once I grab my leakdown tester from work this week. I will use it throughout the entire cycle and measure leakage at different points. (Coming up to tdc..
At tdc.. And after. And compare to a good cylinder.
I'll keep you posted once I grab my leakdown tester from work this week. I will use it throughout the entire cycle and measure leakage at different points. (Coming up to tdc..
At tdc.. And after. And compare to a good cylinder.
Comment