Rb26 in a gts4

[Skym]

On R32 GTS-4, gearbox ratio's match RB20DET. Same with diffhead ratio's in front, rear diffhead's. The 4.363:1 GTS diffhead ratio provide better acceleration over 4.11?:1 diffhead ratio in GTR diffhead's due to being shorter.

The diffhead ratio's have to be the same in front, rear diffhead's.

Driveshaft's are the same diameter.

Also the obvious visual differences when looking at chassis.

Another might be the 4wd ECU's, but have never compared the part numbers.

[cschepp]

Also I would like to know if I will need rb20 motor mounts to accomplish this task. Here is what will be used for the project now:
-26 wiring harness( already there)
-26 motor and trans
-26 rear diff( is this direct bolt in?)

Also this might make things a little easier for me, are the rb20 and 26 awd sub frames the same? If so this swap might take a matter of hours before run time.

[cschepp]

Well beyond the stuff I didn't know I have now researched and found out the answers to all my questions. Thanks for all the help. Rb26 is on it's way and will be in within the month. No more walking!