Help, Code 46, Neo Swapped R32.

[amnash]

trying to get the check engine light off in my r32. first off, the car runs fine, did a neo swap on my r32 and obviously didnt install the traction control system. I had originally bought a stagea ecu to avoid the code(stagea=no traction control) but i now have a mines r34 GTT ecu and the code is back. Basically i need to know how to trick the ecu in thinking the traction control is working.



its code 46:Throttle motor Sensor signal circuit.



theres four wires to the ecu that didnt get hooked up during the swap.

Pin 51: Throttle motor Sensor Signal

Pin53: Motor throttle switch

Pin 37: throttle opening Signal

Pin 79: ECM-TCM, TCS/ABS Integrated Control Signal(multiplex communication)



can i connect two of these four wires? add a resistor somewhere? ground a wire? a big concern is frying my mines ecu so i dont want to just ground a wire and see what happens.. any ideas??

[Skym]

To turn a error code off the sensor or wiring needs to be earthed. You do this with the cat overheat sensor.

There is a how guide to on this type of swap into a R32 GTS-T and what to earth via ECU on one of the forums downunder (SDU or SAU).

I think I'm stating the obvious, but I think it's referring to pin 51, going by the text you have posted on error code, pin 51.

[amnash]

ya im just going to use the stagea ecu i have that doesnt have tcration control so doesnt output the code. going to install nistune in that ecu and all will be good. mines r34 gtt ecu coming for sale in near future.

[future_R34]

That ecu any good for my series 2 rb25?

Hope you get it figured out, and your car is da bomb. Looks perfect!


Sent from my iPhone using Tapatalk

[amnash]

the r33 has a different ecu plug..