Whats happening guys! I'm a relatively new member here so I figured i would share my pride and joy with you guys. She's a 1989 Bayside blue R32 GT-R. I bought her here in Japan about two years ago now and have been treating her well since taking ownership. I've put her through her paces quite a few times on some of Japan's more famous tracks, as well as on the infamous Wangan expressway, and aqua line tunnel. She knows how to hang with the big boys. When i bought her she was putting doing 426whp thanks to a set of HKS 2530 turbos with 272 degree cams on the intake/exhaust. I swapped the turbos out last spring for slightly smaller HKS GT-SS tubros, did some fine tuning and she made around 460whp after that. Here are a few pictures and a part list that are on the car. As of this moment the motor is in a rebuild stage... more on that in a bit
Suspension/Brakes:
Tein monoflex Type RA circuit coilovers
Nismo Control arms
Roll center adjusters
Tein tension rods
Tein rear traction arms
Tein tie rods
Brembo F50 calipers front/rear
Brembo 355mm slotted rotors (front)
Brembo 335mm rotors (rear)
Project Mu race circuit brake pads front/rear
stainless steel brake lines
6 point roll cage
Do-luck b-pillar brace
front/rear strut tower bars
22mm front/rear swap bars
Wheels/tyres:
XXR 527 wheels 18x9.75 +22mm offset
Dunlop Z1 superstar tyres 265/35/18
My new engine setup will come in a later post, so for now enjoy some pics
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
Suspension/Brakes:
Tein monoflex Type RA circuit coilovers
Nismo Control arms
Roll center adjusters
Tein tension rods
Tein rear traction arms
Tein tie rods
Brembo F50 calipers front/rear
Brembo 355mm slotted rotors (front)
Brembo 335mm rotors (rear)
Project Mu race circuit brake pads front/rear
stainless steel brake lines
6 point roll cage
Do-luck b-pillar brace
front/rear strut tower bars
22mm front/rear swap bars
Wheels/tyres:
XXR 527 wheels 18x9.75 +22mm offset
Dunlop Z1 superstar tyres 265/35/18
My new engine setup will come in a later post, so for now enjoy some pics
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
Comment