i found it, the vented coil pack cover!

[DreadedFist]

Just cut the cover. Leave the back part intact so that you can still mount the ignitor properly. Ba dum, chshh... It's a free mod, who cares if it looks ugly

[cobrAA]

ok here is my version of the vented coil cover. I was a bit sketched out with how it was gonna come out but in the end I'm a bit shocked im the only one that has done it, I think it looks awesome...

impressive! clean engine bay by the way

[JDMricer]

thank you

[supersayianjim]

looks very sexy.

[NewLondon]

not definitive evidence by any means, but prior to putting a HKS DLI on my car, it would misfire worse at high boost (600+whp) with the coil pack cover on than with it removed...and that stock cover that had been machined looks badass

Marshall

[Boyscout]

ok here is my version of the vented coil cover. I was a bit sketched out with how it was gonna come out but in the end I'm a bit shocked im the only one that has done it, I think it looks awesome...

where did you get the emblem?

[JDMricer]

searched through 10,000 skyline/nismo/brand emblems on ebay before deciding on that one.

[ms33]

ok here is my version of the vented coil cover. I was a bit sketched out with how it was gonna come out but in the end I'm a bit shocked im the only one that has done it, I think it looks awesome...

After seeing this I had to vent mine, been looking for a while how to vent the cover, but was never happy with the different ways it's been done. This seemed simple and efficient. Cheers.

[Voodoo_ChildR32]

After seeing this I had to vent mine, been looking for a while how to vent the cover, but was never happy with the different ways it's been done. This seemed simple and efficient. Cheers.

If you don't mind me asking, how did ya do it? Looks clean BTW!


Sent from my iPhone using Tapatalk

[frankiman]

clean and simple

[ms33]

If you don't mind me asking, how did ya do it? Looks clean BTW!


Sent from my iPhone using Tapatalk

Hi mate, I cut out the centre using a plasma disk and then finished off with a fine file.

I bought the alloy mesh from ebay and fixed the mesh in place using Plastic padding's Chemical Metal.

Hope this helps.

[pmurr181]

Did mine myself with a whole saw kit. Super easy. Then put some wire mesh behind it.

[nimblestix]

^ I like this