Project Modworks Monster R32 GTR

[r32_nate]

another progress pic, and my new badass heater

[r32_nate]

Got my coil packs all wired up finally (except the 6 pin ignitor delete side, need to dig the car out of snow to do that). It wasnt near as complicated as I thought.

[leung23c]

Hey! How do you manage to use that heater without poisoning yourself? That heater emits CO and CO2 right? I tried something similar and every time I got a huge headache afterward. My heater kicks ass but it will slowly kill me.

Nine runs on kerosene btw.

[louis110]

^ that's a valid concern. There have been incidences where people have used propane stoves to heat their dwellings during major blackouts in the winter, and because the house wasn't vented, people passed out/died.

[r32_nate]

^ that's a valid concern. There have been incidences where people have used propane stoves to heat their dwellings during major blackouts in the winter, and because the house wasn't vented, people passed out/died.

lol i dunno, luck maybe lol. We used to use a forced propane blaster (mr heater) but the smell was terrible, so we switched to this, which emits very little odor. we can be in there for hours and not die so... i can only assume the draft in the garage must keep me alive, despite how my windows are even covered in wrap lol.

[curtisgoodman]

just remember when you get a headache... its time for some fresh air... winters over anyways unless you live where i do

[r32_nate]

did im in new brunswick, winter hasnt even stopped yet lol. we have way more snow here lol. its far from over but yea, ill keep an eye on the old propane poisoning situation lol.

[r32_nate]

Well my clutch finally showed up today, and after a long terrible battle getting the transmission to line up (3 hours), we got the engine in the hole. Gonna button up the mounts and the rest of the tranny bolts tonight, mess around with all the stuff underneath and put the car down tonight.

[r32_nate]

A bit more done tonight. All thats left are the axles (waiting on a boot kit and snap ring), radiator/fans and a couple grounds and its done. Getting my second knee surgery tomorrow so not much will be done over the next week

[r32_nate]

And it looks like I got some new shoes...

[leung23c]

What rims are they? Look like wedssport sa55m! Looks exactly the one I got! Omfg

[r32_nate]

What rims are they? Look like wedssport sa55m! Looks exactly the one I got! Omfg

Advan racing RZ 18x9 +45, made by Yokohama

[steveo1502]

+45? U sure ?

[steveo1502]

Dosnt look like it in the pic but hard to tell on the jack , might need spacers... nice wheels though

[r32_nate]

back said 18x9 and below said 45, im assuming thats +45 lol. I have spacers anyways, like a 20mm or something. they were on it when i got it