Parts List for GT-Rs

[turbo_steve]

Here you go, found this:

http://www.skylinegts.co.uk/Skyline_Parts.htm

and check this out:

http://www.skylinegts.co.uk/Skyline_VIN_plate.htm

I will post more when I get home and find them. This is some useful info here

[klys]

gts-t fuel filter
from napa

Napa gold #3477

[GTR--J]

I used the 1996 Infinity J30 $19.00 @ Crappy Tire...It looked exactly the same as the Jecs fuel filter it came with from Japan.The Z32 filter might fit in the bracket but you might break it trying shove its fat ass in there.You will also have to buy a 90 degree elbow so the fuel line doesn't pinch itself.

[klys]

thanks

[klys]

Okay I changed the status of this thread for:
GTR RELATED parts only

[GTR-Dad]

MyGTR found part numbers for Stop Tech Braided Brake Lines

Front 85-656-4500 ($83 US)
Rear 85-656-5500 ($59 US)

[MyGTR]

I also found Hawk Performance brake pad part numbers...

Street compounds:
FRONT
HPS Part: HB181F.660
Ceramic Part: HB181Z.660
HP Plus Part: HB181N.660

REAR
HPS Part: HB180F.640
Ceramic: Part: HB180Z.640
HP Plus Par: HB180N.640

Go to www.hawkperformance.com if you want the write up on the differences to help you determine which pads are suitable for your application, i.e., the amount of track vs street time your car sees.

I didn't bother to post the pure race applications since I don't know of any of us that have pure track only cars.

[gtr4life]

I do not have part numbers but here are what we can get for tie rods.

Front outer are compatable with a z32
rear inner and outer are compatable with the z32

[dl337j00]

The Z32 [fuel] filter might fit in the bracket but you might break it trying shove its fat ass in there.You will also have to buy a 90 degree elbow so the fuel line doesn't pinch itself.

i used the Z32. youre right its too fat to fit in the bracket. but you dont need an elbow, just remove the bracket alltogather so the filter can float there on an angle, the line reaches perfectly.

[izzy06]

i am wondering if i can use 240's --left front power steering boot-- for my GTR?

thx

[Connor]

I tried a set of sti pads after cross-referencing the part numbers, but they don't fit. the front pad diagram looks way different from the 300zx pad which actually fits, so I have no idea what to make of that.

[GTR--J]

1990- 1998 z32 twin turbo -front outer tie rod
installed no issues

front wheel bearing from z32 DOES NOT FIT.Same outside diameter but the inside diameter is different.I found this out the hard way after the hub came off

[hks_gtr]

Upper Radiator Hose

95 Pathfinder (Needs 2 inches cut off to make a perfect fit)

[hks_gtr]

S13 Upper Control Arm and Upper link same as GTR -Non-Hicas-

[Danno]

windshield wiper blades
driver side: 20" (Napa# 20-3)
passenger: 19" (Napa# 19-3)

Oil filter: same as 240SX (Napa# 21396)