REIMAX (Collar clearances, pics)

[RB2800]

how is the splined drive gear attached to the crank?
thanks

[FRRACER]

It is press fitted to tight clearance, All gears are made from SCM435 steel.

[FRRACER]

I am about to put an order in for 5 more N1 gears, Priced at £430, if you guys do it as a group you should be able to save on postage costs, fully insured is around £60 to Canada.

[RB2800]

I don't understand. Does it press onto the factory crank flats?

[FRRACER]

No, as you would do with the jun collar, you need to machine away the flats.

[bobbo]

I'm not ready yet but I think at this point I'll be going this route.
Thanks for posting.

[RB2800]

thanks for explaining. sorry for asking too many questions.
do you also drill holes for set screws?
does the pump flow more than stock?

[FRRACER]

No worries. Flow rate on the N1 remains the same, no need for screw as the it a very tight press fit.

[FRRACER]

I'm not ready yet but I think at this point I'll be going this route.
Thanks for posting.

No worries let me know when you need a set.

[GTR203]

I'll be in when I tear my engine down , hopfully it won't be for a while as it only has 30k on it